Advertisement
Transporting the Machine
When you wish to mow without the groomer or need
to transport the machine, move the quick-up lever to
the T
position
RANSPORT
Note:
This moves the groomer reel into a raised
position.
Figure 29
1. T
position
RANSPORT
(Figure
29).
2. O
position
PERATION
Maintenance
Changing the Gearbox
Lubricant
Service Interval
After the first 100 hours
Every 500 hours / Yearly (Whichever comes first)
1.
Clean the external surfaces of the groomer
housing.
Important:
clippings on the outside of the groomer
housing; if debris gets inside of the groomer
gearbox, damage may occur.
2.
Remove the drain plug on the bottom of the
housing
(Figure
3.
Remove the fill plug on the side of the housing
and loosen the air-vent plug on the top so air
can pass through
g287375
4.
Align a suitable container beneath the oil-drain
port to catch drained oil.
5.
Tip the cutting unit back onto the kickstand
until the drain port is at the bottom to ensure
complete drainage
1. Remove the drain plug
from the drain port.
2. Remove the fill plug from
the fill port.
6.
Rock the cutting unit back and forth to ensure
complete drainage. When the oil is completely
drained, place the cutting unit on a level surface.
7.
Install the drain plug.
19
Ensure that there is no dirt or
32).
(Figure
32).
(Figure
30).
Figure 30
3. Loosen the air-vent plug.
g346929
Advertisement
