Table of Contents
Advertisement
Operation Manual / TPL65VA32 / VA33
8 Disassembly and assembly / 8.5 Removing cartridge group
© Copyright 2020 . All rights reserved.
Disconnect oil pipes in accordance with enginebuilder's instructions.
u
CAUTION
Oil orifices
There is an orifice for adjusting the oil pressure in each of the two oil
supply pipes of the bearing casing. When the cartridge group, the bear-
ing casing or the turbocharger-is being fitted to the engine, it must be
ensured that the orifices specified for the turbocharger are installed in
both oil supply pipes.
Check that the oil orifices have been correctly installed.
u
Loosen and remove sealing air line (56501) between compressor cas-
u
ing (72000) and variable turbine geometry module (56100).
Remove three studs (72029) at top.
u
Attach lifting device (90190) to compressor casing (72000), then
u
fasten and secure it to crane using lifting gear.
Unscrew nuts (61037).
u
Uniformly press apart compressor casing (72000) using three press-
u
off nuts (61090).
Slightly lift compressor casing (72000) and withdraw it.
u
HZTL2464_EN
Rev.E
March 2020
Advertisement
Table of Contents
