Table of Contents
Advertisement
Operation Manual / TPL65VA32 / VA33
7 Removal and installation / 7.1 Turbocharger weights
7 Removal and installation
7.1 Turbocharger weights
Weight [kg]
7.2 Removing the turbocharger
© Copyright 2020 . All rights reserved.
Lifting gear with a sufficient load limit must be used for removing and
installing the turbocharger. The following weight specification is the
heaviest variant possible. This standard value may deviate from the data
on the rating plate depending on the specification.
Disconnect all gas, air and oil lines in accordance with engine manu-
u
facturer's instructions.
CAUTION
Oil orifices
There is an orifice for adjusting the oil pressure in each of the two oil
supply pipes of the bearing casing. When the cartridge group, the bear-
ing casing or the turbocharger-is being fitted to the engine, it must be
ensured that the orifices specified for the turbocharger are installed in
both oil supply pipes.
Check that the oil orifices have been correctly installed.
u
Unplug the cable connector on the speed sensor.
u
Remove the insulation at the suspension ribs.
u
TPL65: Version with compressor wheel cooling system
Remove air supply line. (See also chapter entitled Preliminary re-
u
marks / Layout and functionality)
Inspect the lifting gear.
u
HZTL2464_EN
TPL65VA32/33
1210
Rev.E
March 2020
Advertisement
Table of Contents
