GE HygroTrace User Manual page 10

Standard Wiring Connections (cont.)
2. Using the flying leads at the other end of the transmitter cable,
connect the transmitter to the power supply and data
acquisition system (DAS) as shown in Figure 4 on page 6.
Refer to Table 1 below for a description of the leads in the
factory-supplied cable.
Table 1: Cable Lead Connections - No PC
Lead
Red
Black
Orange
Blue
Cable Braid
3. Trim any unused leads back to the outer cable jacket in order
to remove the bare tinned wire and prevent accidental short
circuits.
The HygroTrace is now ready for operation.
Note: To remove the probe cable, pull back the spring-loaded
sleeve and pull the cable out of the connector.
HygroTrace Moisture Transmitter
Connection Description
(+) 24VDC 1 AMP
(–) 24VDC 1 AMP
(+) 4-20mA Output
(–) 4-20mA Output
System Ground
September 2007
5