Fujitsu 565Tx User Manual page 159

A p p e n d i c e s
Mass Storage
Floppy Disk Drive
One removable 3.5," floppy disk drive which
accommodates a 1.44MB or a 720KB floppy
disk, Fujitsu Model FPCFDD01.
™
One External Floppy Disk Drive Adapter,
Fujitsu Model FPCFDA01.
Hard Drive
One factory installed 4.0GB, 2.5" (12.7 mm)
fixed hard drive unit.
One optional removable 1.3GB, 2.5" (12.7 mm)
hard drive unit, Fujitsu Model FPCHDD01.
CD-ROM Drive
One removable,factory installed,20-speed
maximum,2.5" (12.7 mm) drive, Fujitsu Model
FPCCD04 (also supports FPCCD03).
Audio
SoundBlaster-compatible 16-bit stereo
PCM/FM sound chip.
Spatializer 3D-Stereo multiple speaker effect
support.
148
Stereo headphone jack, 1 Vrms, or less,
minimum impedance 32 Ohms.
Stereo line in jack, 880 mVrms or less,
minimum impedance 10K Ohms.
Mono microphone jack,125 mV p-p or less,
minimum impedance 10K Ohms.
NTSC/PAL jack,75 ohm.
S-Video jack,75 ohm.
Two built-in spe a kers – 28 mm diameter (stereo ) .
One built-in monaural microphone.
Communication
Internal 33.6 Kbps fax/data/voice modem
(33.6 Kbps data/voice transmission;
14.4 Kbps fax transmission).
One IrDA 1.1 compatible infrared port (4 Mbps).
Video
MPEG-1 video data decompression software.
Zoomed video port via PC Card slot 0.
Pre-Installed Software
Microsoft Windows 95.
® ®
LapLink by Traveling Software.
®
MegaPhone by Cypress Research
®
VirusScan by McAfee Associates.
AudioRack 32 for Windows 95
®
by ESS Technology, Inc.
SoftPEG by CompuCore Multimedia Inc.
®
Others dependent on options purchased.
Input/Output Connections
(Connections may be located on the
MediaConnect.)
One Type III/two Type I/II PC Card slot:
PCMCIA Standard 2.1 with PC CardBus
support; Zoomed video port support
via Slot 0.
One 6-pin mini DIN PS/2 compatible
connector, for external keyboard, external
mouse or external numeric keypad.
One 25-pin D-SUB two-way Centronics type
connector for parallel input/output devices;
bi-directional,output only or ECP.
One 240-pin connector for Bus Expansion,
(Mini-Docking Station).
One 15-pin D-SUB connector for VGA external
monitor (see Displays specifications).
One 9-pin D-SUB connector for RS-232C serial
input/output devices.
One connector for USB (Universal Serial Bus)
input/output devices.