Fujitsu 565Tx User Manual page 123

C A U T I O N
When the Telephone Pass Through
Connector is installed you must lift the left
side first and be very careful not to bend
or break the Telephone Pass Through
Connector while lifting the notebook free
of the Mini-Docking Station.
C A U T I O N
The RJ-11 connector on your Mini-
Docking Station comes with a protective
cover to keep the connector clean. Be
careful to remove it before trying to make
a connection. Save the cover and replace
it when the connector is not in use.
U s e r I n s t a l l a b l e
Using Your Notebook While It Is
Installed In the Mini-Docking Station
There are a few differences you will notice
between using your notebook in and out
of the Mini-Docking Station.
In the Mini-Docking Station you have
added capabilities:
Windows 95 has the addition to the Start
®
Menu of a PC Eject choice between the
Suspend mode and Shutdown selections.
(Use the PC Eject choice to enable the
undocking of your LifeBook.)
Standard AC power source (not the batteries
or power adapter).
Both an external mouse and an external key-
board can be connected at the same time. Be
sure to plug them into the correct PS/2 ports.
There is an additional PC Card slot.
There is a stereo line out jack.
L i f e B o o k
F e a t u r e s
C A U T I O N
When your notebook is mounted in the
Mini-Docking Station it is essentially a
desktop PC not a mobile notebook. DO
NOT unplug the Mini-Docking Station
with the operating system active. You
may cause a loss of data and a system
error when you restart your notebook.
Creating the Windows 95 Mini-Docking
Station Docked Configuration
(This is only necessary if you change notebook
configuration and the first time you dock
your notebook.)
1. Install your notebook in the Mini-Docking
Station.
2. Turn on the power. The operating system will
automatically begin to configure itself for
'docked mode' operation.
3. When the configuring is completes the screen
will tell you to restart your system again.
™ 5 0 0 S e r i e s f r o m F u j i t s u ™
111