Table of Contents
Advertisement
Handset Sound Signals
Signal
A long warning tone
(with ringer on)
Three short beeps
(several times)
One beep every 7 seconds
Troubleshooting Guide
Telephone Solutions
No dial tone
• Check or repeat installation steps:
Make sure the base power cord is connected to a working electrical outlet.
Make sure the telephone line cord is connected to the base and the wall jack.
• Connect another phone to the same jack. If it doesn't work, the problem might be your wiring or local service.
• The handset may be out of range of the base. Move closer to the base.
• Make sure the battery is properly charged (for 16 hours).
• Make sure the battery pack (in the handset) is properly installed.
• The handset should beep when you press the
should be lit when the handset rests in the cradle. If not, the battery may need to be charged.
• Place handset in charge cradle for at least 20 seconds to reset the unit.
Handset does not ring
• Make sure the handset ringer software switch is set to on.
• The handset may be out of range of the base. Move closer to the base.
• You may have too many extension phones on your line. Try unplugging some extensions.
• Check for a dial tone.
You experience static, noise, or fading in and out
• The handset may be out of range of the base. Move closer to base.
• Make sure base is not plugged into an electrical outlet with another household appliance. If necessary, relocate
the base.
• Charge the battery (for 16 hours).
Unit beeps
• Clean the charging contacts on the cordless handset and base charge cradle with a soft cloth or an eraser.
• See solutions for "No dial tone" on previous page.
• Replace the battery.
Memory dialing doesn't work
• Did you program the memory location keys correctly?
• Did you follow proper dialing sequence?
Unit locks up and no communication between the base and cordless handset
• Unplug the power adaptor from the electrical outlet and the back of the base. Remove the handset battery. Wait
for 30 seconds and plug the power adaptor back into the base and electrical outlet. Reconnect the battery and
charge for 16 hours.
Caller ID Solutions
No Display
Meaning
Signals an incoming call
Page signal
Low battery warning
TALK or SPEAKER
button, and the charge indicator on the base
Advertisement
Table of Contents
