Table of Contents
Advertisement
below to return to the factory default settings.
From the Handset Setup Menu:
1. Press the caller ID-volume (6 or 5) button to scroll to the DEFAULT SETTING sub-menu.
2. Press the
mute/menu OK
default setting is 2NO.
3. Use the touch-tone pad to select 1YES or 2NO, or use the caller ID-volume (6 or 5) button to move the
cursor to 1YES or 2NO.
NOTE: If you choose YES all the settings in the programmable menu are returned to factory default
setting.
4. Press the
mute/menu OK
Telephone Operation
Visual Indicators
Base
The
charge/in use voicemail
you have a message waiting from your service provider. The indicator will remain lit when a handset is in the base
charging or when the line is in use.
Handset
The
TALK
and SPEAKER indicator buttons flash when you receive a call and remain lit during a call.
The keypad and CID will also light when a call is received.
VMWI / Visual Ringer Indicator on Handset
IMPORTANT: In order to use this unit's Voice Mail Waiting Indicator (VMWI) feature, you must
subscribe to this service from your phone company.
The VMWI indicator on the top of the handset flashes when you receive a new message from your service
provider. Also, it serves as a Visual Ringer function. It will flash when there is an incoming call.
Speakerphone Operation
NOTE: If you are using the speakerphone, remain close to handset so the party you are speaking to
can hear you.
If you are using the handset and want to switch to the speakerphone, press the SPEAKER button, press
END/cancel
to end conversation.
If you are using the speakerphone and want to switch to the handset, press the
again to end conversation.
Making a Call
1. Press the
TALK
or SPEAKER button. Dial the desired number.
- OR -
Dial the number first, then press the
- OR -
Press the caller ID-volume (6 or 5) button to select the desired record, then press the
button.
2. When finished, press the
NOTE: You may enter up to 32 pre -dial digits.
NOTE: If you want to delete the pre-dial number you entered, press the
until all of the digits are erased.
Answering Calls
1. When the phone rings, press the SPEAKER button on the handset.
button to enter the menu. DEFAULT SETTING 1YES 2NO shows in the display. The
button to save your selection. You will hear a confirmation tone.
indicator on the base will flash to alert you to an incoming call, during paging, or if
TALK
or SPEAKER button.
END/cancel
button to hang up.
TALK
button, press
END/cancel
TALK
or SPEAKER
delete/intercom/conf
button
Advertisement
Table of Contents
