Quick Start Function - Canon HR10 Instruction Manual

i!i i ii!i::ii[[Ji ¸ ii([!
• You can also use the T and W buttons
on the wireless controller or the LCD
panel. The zoom speed will be the same
as with the camcorder or fixed at
[_SPEED 3] (when [_VARIABLE] is
selected).
• When set to [_VARIABLE], the zoom
speed will be faster in record pause
mode.
Quick Start Function
When you press [QUICK
START}
the
camcorder enters the 1_ standby
mode. In standby mode the camcorder
consumes only about half the power
used when recording, saving energy
when you are using a battery pack.
Additionally, when you press
EQUICK START}
again the camcorder is
ready to start recording within approx.
1 second, ensuring you do not miss
important shooting opportunities.
then stays on when it enters the
standby mode.
2
When you wish to resume
recording, press
[QUICK STARTj
again.
Within approx. 1 second, the
camcorder is ready in record pause
mode.
_'_ NOTES
• When you wake up the camcorder from
standby mode, the following settings
will be changed automatically:
- Manual focus returns to automatic
focus (AF).
- Manual exposure adjustment returns
to automatic exposure.
- Zoom position returns to full wide
angle W.
• The camcorder will shut off if left in
standby mode for 10 minutes,
regardless of the [POWER SAVE] setting
(L[J 52). You can select the length of
time until shut-oft with the [_ STANDBY
OFF] setting (L_ 53).
To restore the power if the camcorder
shut oft, slide the _ switch toward
MODE and release it, or move the
switch to _ and back to ON
again.
• If you perform any of the following
actions while in standby mode (while the
standby lamp is on), the camcorder will
return to record pause mode.
- Open the disc compartment cover.
- Change the position of the _,_,/_
switch.
- Slide the _ switch toward MODE.
1 Press [QUICK STARTJfirmly.
The standby lamp flashes at first
while the camcorder is preparing and
39