Basic Recording; Taking Photos - Canon HR10 Instruction Manual

A
Photos
Refer to this chapter for details on shooting photos - from capturing
and playing back images to printing them.
Basic Recording
Taking Photos
Before using a memory card for the
first time, be sure to initialize it with
this camcorder ([J 84).
(Q3 26)
1
Move the _ switch to ON to
set the camcorder in CAMERA
mode.
The red CAMERA indicator will turn
on.
2
Move the ',_,/_ switch to _:_ (Still
images),
3 Press _ halfway.
• Once the focus is automatically
adjusted, O will turn green and
one or more AF frames will appear.
• When you press _ on the
wireless controller, the still image is
recorded immediately.
4
Press _ fully.
The CARD access indicator will flash
as the still image is being recorded.
IMPORTANT
Avoid the following actions while the card
access display (_ q ) appears on screen,
and when the CARD access indicator is on
or flashing. Failing to do so may result in
permanent data loss.
- Do not subject the camcorder to
vibrations or strong impacts.
- Do not open the memory card slot cover
and do not remove the memory card.
- Do not disconnect the power source or
turn off the camcorder.
- Do not change the position of the ,m/Q
switch or the operating mode.
_'_ NOTES
• If the subject is not suitable for
autofocus, @ turns yellow. Adjust the
focus manually (Q3 59).
• When the subject is too bright,
"OVEREXR" starts flashing. In such
case, use the optional FS-H37U
ND filter.
72