Nokia ONT Product Manual page 64

Install a XS-2426G-A indoor ONT
Procedure
Fiber cables transmit invisible laser light. To avoid eye damage or blindness, never look directly
into fibers, connectors, or adapters.
Be careful to maintain a bend radius of no less than 1.5 in. (3.8 cm) when connecting the fiber
optic cable. Too small of a bend radius in the cable can result in damage to the optic fiber.
Connect the fiber optic cable with SC/APC adapter to the SC/APC connector on the bottom of
the ONT.
Note: Fiber cable preparation varies depending on the type and size of the inside or
outside plant fiber cable being spliced to the SC/APC fiber optic pigtail cable.
6
Connect the power cable to the power connector.
7
Power up the ONT unit by using the power switch.
8
If used, enable the Wi-Fi service.
a. Locate the WLAN button on the ONT; see
(p. 63)
b. Press the WLAN button to change the status of the Wi-Fi service.
9
Verify the ONT LEDs, voltage status, and optical signal levels; see the Nokia ONT Hardware
and Cabling Installation Guide.
10
Activate and test the services; see the Nokia ONT Hardware and Cabling Installation Guide.
11
If necessary, reset the ONT.
a. Locate the Reset button on a XS-2426G-A indoor ONT as shown in
2426G-A ONT connections" (p.
64
DANGER
Hazard
WARNING
Equipment Damage
for location of the WLAN button.
Nokia – Proprietary and Confidential
Use pursuant to applicable agreements
3FE-49348-AAAA-TCZZA
Figure 6-1, "XS-2426G-A ONT connections"
63).
Nokia ONT
Figure 6-1, "XS-
December 2020
Issue 1