Mitsubishi Electric 800 Series Instruction Manual page 66

• When one encoder is shared between the FR-A8AP and CNC (computerized numerical controller), its output signal should
be connected as follows. In this case, the wiring length between the FR-A8AP and CNC should be as short as possible,
within 5 m.
NOTE
• For the details of the optional encoder dedicated cable (FR-JCBL/FR-V7CBL), refer to .
• The FR-V7CBL is provided with a P-clip for earthing (grounding) shielded cables.
Inverter
Encoder
(FR-A8AP)
CNC
Maximum 5 m
(two parallel cables)
2. Installation and Wiring
2.7 Connection to a motor with encoder (Vector control)
1
2
3
4
5
6
7
8
9
10
65