Servicing The Bedbar - Toro Reelmaster 3100-D Series Operator's Manual

Servicing the Bedbar

Removing the Bedbar
1. Turn the bedbar-adjuster screws counterclockwise to
back the bedknife away from the reel
1. Bedbar-adjusting screw
2. Spring-tension nut
2. Back out the spring-tension nut until the washer is no
longer tensioned against the bedbar
3. On each side of the machine, loosen the locknut
securing the bedbar bolt
1. Bedbar bolt
4. Remove each bedbar bolt, allowing the bedbar to
be pulled downward and removed from machine
bolt (Figure 31). Account for 2 nylon washers and
1 stamped steel washer on each end of the bedbar
(Figure 32).
(Figure
Figure 30
3. Bedbar
4. Washer
(Figure
(Figure 31).
Figure 31
2. Locknut
30).
1. Bedbar bolt
2. Nut
Assembling the Bedbar
1. Install the bedbar, positioning the mounting ears
between the washer and the bedbar adjuster.
2. Secure the bedbar to each side plate with the bedbar
bolts (nuts on bolts) and 6 washers.
3. Position a nylon washer on each side of the side-plate
boss.
30).
4. Place a steel washer outside each of the nylon washers
(Figure
Note: Torque the bedbar bolts to 37 to 45 N∙m (27
to 33 ft-lb). Tighten the locknuts until the outside steel
washer stops rotating and end play is removed, but do
not overtighten or deflect the side plates. The washers
on the inside may have a gap.
5. Tighten the spring-tension nut until the spring is
collapsed, then back off 1/2 turn
1. Spring-tension nut
17
Figure 32
3. Steel washer
4. Nylon washer
32).
g016648
Figure 33
2. Spring
(Figure 33).
2
1