Fan - HP Pavilion 14 Maintenance And Service Manual

Fan

Description
Fan
NOTE: To properly ventilate the computer, allow at least 7.6 cm (3.0 in) of clearance on the left side of the
computer. The computer uses an electric fan for ventilation. The fan is controlled by a temperature sensor and
is designed to turn on automatically when high temperature conditions exist. These conditions are affected by
high external temperatures, system power consumption, power management/battery conservation
configurations, battery fast charging, and software requirements. Exhaust air is displaced through the
ventilation grill located on the left side of the computer.
Before removing the fan, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
To remove the fan:
1. Remove the two Phillips PM2.0×4.0 screws (1) that secure the fan to the computer.
2. Lift the fan up enough to access the cable and connector on the system board (2).
3. Disconnect the fan cable from the system board (3).
Reverse this procedure to install the fan.
IMPORTANT:
Bottom cover on page
Battery on page
Be sure to connect the fan cable to the system board connector first when installing the fan.
27).
29).
Component replacement procedures
Spare part number
930603-001
39