M.2 Solid-State Drive Adapter Bracket And Board - HP Pavilion 14 Maintenance And Service Manual

M.2 solid-state drive adapter bracket and board

Description
Solid-state drive adapter bracket
Solid-state drive adapter board
Solid-state drive board cable
Before removing the solid-state drive adapter bracket and board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
To remove the solid-state drive adapter bracket and board:
1. Disconnect the cable from the system board connector (1).
2. Remove the three Phillips PM2.0×3.0 screws (2) that secure the bracket to the computer.
3. Lift the bracket and board assembly out of the computer (3)
36 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
Bottom cover on page
Battery on page 29).
27).
Spare part number
L00160-001
L00159-001
L01440-001