JVC CA-MXS6MDR Service Manual page 7

Removing the font panel assembly
Prior to performing the following procedure, remove
the top cover.
1. Disconnect the wire from connector CN603 on the
input board and the card wire from CN801 on the
microcomputer board.
2. Remove the two screws E on the bottom of the body.
3. Release the joint a on the bottom and the two joints
b and c on the lower sides of the body using a
screwdriver. Detach the front panel assembly toward
the front.
Microcomputer board
Fig.8
Removing the display board (See Fig.9)
Prior to performing the following procedure, remove
the top cover and the front panel assembly.
1. Remove the nine screws F
board to the front panel assembly.
2. Disconnect connector CN791 on the display board
from the control board on the front panel assembly.
Removing the control board / the key
board (See Fig.10)
Prior to performing the following procedure, remove
the top cover, the front panel assembly and the
display board.
1. Remove the five screws G and the four screws H
attaching the control board and the key board.
REFERANCE: When removing the control board and
the key board respectively, unsolder
each board.
(See Fig.6 to 8)
Front panel assembly
c
CN801
Joint
attaching the display
Front panel assembly
E
Fig.6
CN603
Front panel assembly
b
Joint
Fig.7
F
F
CN791
F
Fig.9
Front panel assembly
H
G
G
Soldering
Fig.10
CA-MXS6MDR
SP-MXS6MD
a
Joint
E
Input board
Front panel assembly
F
Display board
Key board
G
Control board
H
1-7