JVC CA-MXS6MDR Service Manual page 29

<Speaker section>
Information
This is a method of dis assembly.
As parts of the repair of this speaker
system, it is only the speaker box assemblies.
It is not possible to supply with each part unit.
Prior to performing the following procedure, remove
the front grille.
Removing the speaker (woofer)
1. Insert a screwdriver under the ornament grille
attached to the woofer.
2. Pull out the ornament grille with each boss by means
of a lever as shown in Fig.2.
ATTENTION: As the ornament grille is damaged,
replace it with the woofer.
ATTENTION: When replacing the ornament grille,
make sure the boss with adequate
amount of bond.
3. Remove the four screws A and the woofer from the
body. Disconnect the wire from the speaker
terminals.
(See Fig.1,3 to 5)
Woofer
Ornament grille
Boss
Ornament grille
Fig.1
Stick
Fig.2
Fig.3
CA-MXS6MDR
SP-MXS6MD
Tweeter
Woofer
Boss
Boss
Ornament grille
Push
Driver
Boss 4
1-29