Disassembly Method - JVC CA-MXS6MDR Service Manual

CA-MXS6MDR
SP-MXS6MD

Disassembly method

<Main body>
Removing the top cover
1. Remove the four screws A on the back of the body.
2. Remove the two screws B on both sides of the body.
3. Lift up the rear part of the top cover while pulling
both sides, then remove the top cover.
Removing the CD changer mechanism
assembly (See Fig.3 to 5)
Prior to performing the following procedure, remove
the top cover.
1. Disconnect the card wire from connector CN661 on
the input board.
2. Remove the four screws C on the upper side of the
body.
3. Remove the screw D on the left side of the body.
4. Release the wires from the clamp on the right side of
the CD changer mechanism assembly. Lift up the
rear part of the CD changer mechanism assembly
and pull out it from the front assembly.
CD changer mechanism assembly
1-6
(See Fig. 1 and 2)
Clamp
Fig.5
Top cover
A
A
Fig.1
A
A
Fig.2
CD changer mechanism assembly
C
C
Fig.3
CD changer mechanism assembly
D
Fig.4
A
A
Top cover
B
2
A
C
CN661
Input board
C
Front panel assembly