JVC CA-MXS6MDR Service Manual page 26

CA-MXS6MDR
SP-MXS6MD
Removing the flap base unit and the gear
base unit (See Fig.13 and 14)
Prior to performing the following procedures, remove
the servo control board, the top cover, the tray unit,
the side unit (L) and the side unit (R).
1. Remove the screw E attaching the flap base unit.
Release the joint tabs i and j, then remove the flap
base unit from the body.
2. Remove the belts from the two pulleys on the gear
base unit.
3. Remove the three screws F and remove the gear
base unit from the body.
Removing the motors (See Fig.15)
Prior to performing the following procedure, remove
the main board.
1. Remove the belts from the two pulleys.
2. Remove the four screws G and detach each motor
from the body.
1-26
Flap base unit
Joint tab j
Joint tab i
Fig.13
F
Gear base unit
Fig.14
Fig.15
E
F
Belt
F
Belt
Motor
G
G
Motor