Yamaha Electone STAGEA ELC-02 Owner's Manual page 206

Troubleshooting
Problem
RHYTHM PROGRAM
During use of the Rhythm Pattern Program,
no sound is produced even when you play a
certain percussion sound.
MUSIC DATA RECORDER
The USB flash drive is not recognized.
Recording or playback cannot be
performed.
Recording is stopped before the
performance is finished.
An error message appears while entering a
folder name or Song name.
The rhythm does not start at the beginning of
a recording, or stops in the middle of the
performance.
The notes of the recording are "stuck" and
sound continuously.
206 ELC-02/ELCU-M02 Owner's Manual
Possible Cause and Solution
If percussion sounds have been recorded while memory is full, no subsequently
selected instruments can be heard or recorded. If necessary, erase some of the less
necessary percussion sounds and play again.
Check whether the connected USB flash drive is supported or not from the website
below:
http://download.yamaha.com/
• The part buttons in the Rec Standby display or Playing display may have been
turned off. Turn the desired part to REC or PLAY.
• The performance data is too large. The maximum limit for recording performance
data is 1 MB.
• The amount of recorded data on the USB flash drive is close to the maximum limit.
Either use another USB flash drive or delete the data of unnecessary Songs.
• When you overwrite the Song, the length of a subsequently recorded part cannot
exceed the length of the previously recorded parts. Delete the previously recorded
Song, then record again (page 126)
• The performance data is too large. The maximum limit for recording performance
data is 1 MB.
• The folder/Song name is too long. The capacity is 50 letters.
• The folder/Song name may be an invalid name. Refer to page 115.
• The path name is too long. The capacity of the path name is 234 letters. Reduce
the layer or shorten the folder/Song name to shorten the path.
The MDR is designed so that the rhythm cannot be started at the very beginning of a
recording. If you wish to use the rhythm, start it after the time indicator appears in the
display.
During playback, you may have removed the USB flash drive. Whenever you wish to
stop playback, always press the [J] (Stop) button before removing the USB flash
drive.