Yamaha Electone STAGEA ELC-02 Owner's Manual page 182

Accessory Jacks and Controls
6
6 FOOT PEDAL jack
For connecting to a Foot Pedal (sold separately).
Reference page
• Foot Pedal (Sold Separately) (page 176)
7 MIDI IN/OUT terminals
For connecting external MIDI devices such a synthesizer
or sequencer. You can also use these to connect with a
computer that has a MIDI Interface.
Reference pages
• Controlling external MIDI devices from the Electone
(page 185)
• Controlling the Electone from an external device (page 186)
• Connection with Computer (page 187)
8 USB terminals
8-1 [USB TO HOST] terminal
For connecting to a computer with a USB cable. To
connect to a computer, make sure that an
appropriate USB-MIDI driver is installed to the
computer.
Reference page
• Connection with Computer (page 187)
8-2 [USB TO DEVICE] terminal
For connecting USB storage devices (such as USB
flash drive).
USB
USB is an abbreviation for Universal Serial Bus. It is a serial
interface for connecting a computer with peripheral
devices.
9 TO PEDAL terminal
For connecting to the Pedal Unit.
Reference page
• Connecting a Pedal Unit (page 186)
182 ELC-02/ELCU-M02 Owner's Manual
7 8
8 8
-1 -2
9 )
!
-1
) AUX IN (Phone; L/L+R, R) jacks
This pair of stereo phone jacks is for connection to an
external device. The signal from the connected external
device sounds from external speakers connected to the
Electone.
Reference page
• Outputting the Sound of an external device through the
external speakers of the Electone (page 185)
! AUX OUT (LEVEL FIXED) jacks
!-1 SUB (1, 2) jacks
For connection to an external amplifier/speaker
system. These outputs can be selected for each part.
The output level is fixed and cannot be controlled
with the MASTER VOLUME dial.
!-2 MAIN (L/L+R, R) jacks
This set of stereo outputs is for connection to an
external amplifier/speaker. The output level is fixed
and cannot be controlled.
Reference pages
• Playing the sounds of the Electone through an external audio
system (page 183)
• Recording the sounds of the Electone to an external recorder
(page 184)
@ OUTPUT (L/L+R, R) jacks
This set of stereo outputs is for connection to an external
amplifier/speaker. Connect the included speakers.
The output level can be controlled.
NOTE
• While using the headphone jack, the sound is not outputted from
the OUTPUT jacks.
• Speakers are not included with the ELCU-M02. Use commercially
available powered speakers.
Reference page
Recording the sounds of the Electone to an external recorder
(page 184)
! @
!
-2