Table of Contents
Advertisement
Using the MDR Display
Precautions when using the
[USB TO DEVICE] terminal
This instrument is equipped with the three [USB TO
DEVICE] terminals as follows:
• Two [USB TO DEVICE] terminals at the right front of
the keyboard.
• One [USB TO DEVICE] terminal at the rear side of the
instrument.
NOTE
For more information about the handling of USB devices, refer to
the owner's manual of the USB device.
Compatible USB devices
• USB flash drive
• USB wireless LAN adaptor
Other USB devices such as a computer keyboard or
mouse cannot be used.
Although USB devices 1.1 to 3.0 can be used on this
instrument, the amount of time for saving to or loading
from the USB device may differ depending on the type of
data or the status of the instrument.
The instrument does not necessarily support all
commercially available USB devices. Yamaha cannot
guarantee operation of USB devices that you purchase.
Before purchasing a USB device for use with this
instrument, please visit the following web page:
http://download.yamaha.com/
NOTE
The rating of the [USB TO DEVICE] terminal is a maximum of 5V/
500mA. Do not connect USB devices having a rating above this,
since this can cause damage to the instrument itself.
Connecting USB device
When connecting a USB device to the [USB TO
DEVICE] terminal, make sure that the connector on the
device is appropriate and that it is connected in the
proper direction.
NOTICE
• Avoid connecting or disconnecting the USB flash drive
while executing playback/recording and file management
operations (such as Save, Copy, Delete and Format), or
when accessing the USB flash drive. Failure to observe
this may result in "freezing" of the operation of the
instrument or corruption of the USB flash drive and the
data.
108
ELC-02/ELCU-M02 Owner's Manual
• When connecting then disconnecting the USB flash drive
(and vice versa), make sure to wait more than 6 seconds
between the two operations.
• When connecting a USB cable, make sure that the length
is less than 3 meters.
NOTE
When you use a USB device other than a USB flash drive,
connect it to the [USB TO DEVICE] terminal at the rear side of
the instrument.
Using USB flash drives
By connecting the instrument to a USB flash drive, you
can save data you've created to the connected device, as
well as read data from the connected device.
Maximum number of USB flash drives
allowed
Up to three USB flash drives can be connected to the
[USB TO DEVICE] terminal.
Formatting USB flash drive
You should format the USB flash drive only with this
instrument (page 109). A USB flash drive formatted on
another device may not operate properly.
NOTICE
The format operation overwrites any previously existing
data. Make sure that the USB flash drive you are formatting
does not contain important data. Proceed with caution,
especially when connecting multiple USB flash drive.
Turning off the instrument
When turning off the instrument, make sure that the
instrument is NOT accessing the USB flash drive by
playback/recording or file management (such as during
Save, Copy, Delete and Format operations). Failure to do
so may corrupt the device and the data.
Advertisement
Table of Contents
