Table of Contents
Advertisement
1
Figure 41
1. Alternator belt
2. Brace
3.
Loosen the bolt securing the brace to the engine
and the bolt securing the alternator to the brace.
4.
Insert a pry bar between the alternator and
engine and pry out on the alternator.
5.
When proper tension is achieved, tighten the
alternator and brace bolts to secure adjustment.
Cooling Fan Belt (Fig. 42)
1.
Loosen the lock nut on the belt tensioner lever.
2.
Apply 7–14 Nm of force at the end of the lever
to set the proper tension on the fan belt.
2
Figure 42
1. Cooling fan belt
2. Tensioner lever
3.
Tighten the lock nut to secure adjustment.
Maintenance
2
1
– 32 –
Adjusting the Throttle
1.
Position the throttle lever forward so that it
stops against the seat base slot.
2.
Loosen the throttle cable connector on the lever
arm at the injection pump.
3.
Hold the injection pump lever arm against the
high idle stop and tighten the cable connector.
Note: When tightened, the cable connector must
be free to swivel.
4.
Torque the lock nut to 54–75 Nm. The
maximum force required to operate the throttle
lever should be 27 Nm.
➀
Figure 43
1. Injection pump lever a8rm
Changing Hydraulic Fluid
CAUTION
Before servicing or making adjustments to the
machine, stop the engine and remove the key from
the switch.
Change hydraulic fluid after every 800 operating
hours, in normal conditions. If fluid becomes
contaminated, contact your local TORO distributor
because the system must be flushed. Contaminated
fluid looks milky or black when compared to clean
oil.
1.
Turn the engine off and raise the hood.
Advertisement
Table of Contents
