Table of Contents
Advertisement
Greasing Bearings and
Bushings
The machine has grease fittings that must be
lubricated regularly with No. 2 General Purpose
Lithium Base Grease. If the machine is operated
under normal conditions, lubricate all bearings and
bushings after every 50 hours of operation.
Lubricate bearings and bushings immediately after
every washing regardless of the interval listed.
1.
The grease fitting locations and quantities are.
Engine Drive shaft (3), (Fig. 23); Cutting unit
carrier frame and pivot (2 each), (Fig. 24); Rear
lift arm pivots (2), Drive shaft clutch (1) (Fig.
25); Rear axle tie rod (2), Steering cylinder ball
joints (2), Axle steering pivots (2) Rear axle
pivot (1) (Fig. 26); Traction control linkage at
transmission (1), Drive shaft support bearing
(1), Rear axle drive shaft (3) (Fig. 27); Brake
pedal (1) (Fig. 28); Lift cylinders (5) (Fig. 29),
front lift arm pivots (3) (Fig. 30) and fan drive
pulley (Fig. 31).
Figure 23
Figure 24
Maintenance
– 26 –
Figure 25
Figure 26
Figure 27
Figure 28
Advertisement
Table of Contents
