Table of Contents
Advertisement
2.
Attach a suitable chain, strap or cable to the
center of the front frame member (Fig. 19).
Figure 19
1. Center of front frame member
Note: Lock both brake pedals together before
towing.
3.
Attach the other end of the towing device to a
vehicle that is capable of towing the machine
safely at speeds below 4.8 kmh.
4.
An operator must be on the machine to steer it
and keep the traction pedal fully depressed in
the forward position while towing.
5.
When towing is completed, reinstall the drive
shaft as shown in Figure 18. (The splines are
designed to allow assembly only when the two
halves of the shaft are properly oriented.)
Diagnostic Light
The RM 5500-D is equipped with a diagnostic light
that indicates if the electronic controller is
functioning correctly. The green diagnostic light is
located under the control panel, next to the fuse
block. When the electronic controller is functioning
correctly and the key switch is moved to the ON
position, the controller diagnostic light will be
illuminated. The light will blink if the controller
detects a malfunction in the electrical system. The
light will stop blinking and automatically reset
when the key switch is turned to the OFF position.
Operation
➀
– 20 –
➀
Figure 20
1. Electronic controller light
When the controller diagnostic light blinks, one of
the following problems has been detected:
1.
One of the outputs has been shorted.
2.
One of the outputs has an open circuit.
Using the diagnostic display, determine which
output is malfunctioning; refer to Checking
Interlock Switches.
If the diagnostic light is not illuminated when the
key switch is in the ON position, the electronic
controller is not operating. Possible causes are:
1.
Connector is not connected.
2.
The light is burned out.
3.
Fuses are blown.
4.
Not functioning correctly.
Check electrical connections, input fuses and the
diagnostic light bulb to find the malfunction. Make
sure the connector is secured to the wire harness
connector.
Diagnostic ACE Display
The RM5500-D is equipped with an electronic
controller that controls most machine functions. The
controller determines what function is required for
various input switches (i.e., seat switch, key switch,
etc.) and turns on the outputs to actuate solenoids or
relays for the requested machine function.
For the electronic controller to control the machine
as desired, each of the input switches, output
solenoids and relays must be connected and
functioning properly.
The Diagnostic ACE display is a tool to help the
Advertisement
Table of Contents
