Specifications; Attachments/Accessories; Operation; Adding Fuel - Toro 31230N Operator's Manual

1. Fuel gauge

Specifications

Note: Specifications and design are subject to change
without notice.
Length
Width (Rear Wheels)
Height (with Roll Bar Up)
Height (with Roll Bar Down)
Weight

Attachments/Accessories

A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.
Figure 6
2. Fuel tank cap
241.3 cm (95 inches)
144.8 cm (78 inches)
144.8 cm (78 inches)
54 inches (137.2 cm)
2187 lb (992 kg)

Operation

Note: Determine the left and right sides of the machine
from the normal operating position.
CAUTION
This machine produces sound levels in excess of 85
dBA at the operators ear and can cause hearing loss
through extended periods of exposure.
Wear hearing protection when operating this
machine.

Adding Fuel

Use only clean, fresh diesel fuel or biodiesel fuels with low
(<500 ppm) or ultra low (<15 ppm) sulfur content. The
minimum cetane rating should be 40. Purchase fuel in
quantities that can be used within 180 days to ensure fuel
freshness.
Fuel tank capacity: 51.1iters (13.5 US gallons)
Use summer grade diesel fuel (No. 2-D) at temperatures
above -7° C (20° F) and winter grade (No. 1-D or No.
1-D/2-D blend) below that temperature. Use of winter grade
fuel at lower temperatures provides lower flash point and
cold flow characteristics which will ease starting and reduce
fuel filter plugging.
Use of summer grade fuel above -7° C (20° F) will contribute
toward longer fuel pump life and increased power compared
to winter grade fuel.
Important: Do not use kerosene or gasoline instead of
diesel fuel. Failure to observe this caution will damage
the engine.
WARNING
Fuel is harmful or fatal if swallowed. Long-term
exposure to vapors can cause serious injury and
illness.
• Avoid prolonged breathing of vapors.
• Keep face away from nozzle and fuel tank or
conditioner opening.
• Keep fuel away from eyes and skin.
Biodiesel Ready
This machine can also use a biodiesel blended fuel of up
to B20 (20% biodiesel, 80% petrodiesel). The petrodiesel
portion should be low or ultra low sulfur. Observe the
following precautions:
•
The biodiesel portion of the fuel must meet specification
ASTM D6751 or EN14214.
•
The blended fuel composition should meet ASTM D975
or EN590.
•
Painted surfaces may be damaged by biodiesel blends.
14