Table of Contents
Advertisement
1. Traction pedal
2. Stop bolt w/ jam nut
(forward)
4. Adjust the stop bolt all the way in (away from the
traction pedal).
5. Using your hand, push the traction pedal all the way
forward, with light pressure, until it stops and hold it
there. Maintain only light pressure on the pedal when
pushing it to the full forward position.
6. With the seat in the raised position, verify that you
are not over loading the linkage by making sure
the transmission does not move when the pedal is
depressed to the stop.
7. Adjust the stop bolt out (towards the traction pedal)
until there is a gap of 1.5 mm (0.060 inch) between the
head of the stop bolt and the bottom of the traction
pedal.
8. Tighten the jam nut to secure the stop bolt in place.
9. The reverse stop bolt may be adjusted if the maximum
reverse speed is not acceptable. For a faster reverse
speed, adjust the stop bolt in. For a slower reverse
speed, adjust the stop bolt out.
Adjusting the Mow Speed
Limiter Lever
The mow speed limiter lever (Figure 41) can be flipped
forward to limit the traction speed while operating.
1. Disengage the PTO, release the traction pedal to the
neutral position and set the parking brake.
2. Move the throttle lever to the Slow position, stop the
engine, remove the key, and wait for all moving parts to
stop before leaving the operating position.
3. Loosen the jam nut on the mow speed limiter stop bolt
(Figure 41).
Figure 40
3. 0.060 inch (1.5 mm)
4. Stop bolt w/ jam nut
(reverse)
1. Mow speed limiter lever
4. Thread the stop bolt in to increase the mow speed and
out to decrease the mow speed.
5. Tighten the jam nut to lock the adjustment.
6. Rotate the mow speed limiter lever down, operate the
machine to verify the adjustment and readjust the stop
bolt as required.
40
Figure 41
2. Stop bolt w/ jam nut
Advertisement
Table of Contents
