Adjusting The Mirrors - Toro 31598 Operator's Manual

Note: The side cutting unit castor wheels should
remain on the ground with counterbalance applied.
Note: If adjustments need to be made to match the
cut between the front and side cutting units, make the
adjustments to the side cutting units only.
3. If the inside edge of the side cutting unit is too high
relative to the outside edge of the front cutting unit,
remove one 1/8 inch shim from the bottom of the
front inside castor arm on the side cutting unit
33 and Figure 34). Recheck measurement between
outside edges of both side cutting units and inside edge
of side cutting unit to outside edge of front cutting unit.
4. If inside edge is still too high, remove an additional 1/8
inch shim from bottom of front inside castor arm of
the side cutting unit and one 1/8 inch shim from the
front outside castor arm of the side cutting unit
33 and Figure 34).
5. If the inside edge of the side cutting unit is too low
relative to the outside edge of the front cutting unit,
add one 1/8 inch shim to the bottom of the front
inside castor arm on the side cutting unit
and Figure 34). Check measurement between outside
edges of both side cutting units and inside edge of side
cutting unit to outside edge of front cutting unit.
6. If inside edge is still too low, add an additional 1/8 inch
shim to the bottom of front inside castor arm of the
side cutting unit and add one 1/8 inch shim to the
front outside castor arm of the side cutting unit.
7. Once cutting height matches at the edges of front and
side cutting units, verify that side cutting unit pitch is
still 7.6 mm (0.300 inch). Adjust as necessary.
Figure 33
1. Tensioning cap
2. Spacers (4)
3. Shims (2 top and 2 bottom)
(Figure
(Figure
(Figure 33
4. Top axle mounting hole
5. Castor wheel
1. Left front outside castor
arm
2. Left front inside castor arm 4. Right front outside castor

Adjusting the Mirrors

Rear View Mirror
While sitting in the seat, adjust the rear view mirror
35) to attain the best view out the rear window. Pull the lever
rearward to tilt the mirror to reduce the brightness and glare
of light.
Side View Mirrors
While the sitting in the seat, have a helper adjust the side view
mirrors (Figure 35) to attain the best view around the side of
the machine.
1. Side view mirrors
2. Rear view mirror
33
Figure 34
3. Right front inside castor
arm
arm
Figure 35
3. Lever
(Figure