Checking The Tire Pressure - Toro 31598 Operator's Manual

WARNING
Fuel is harmful or fatal if swallowed. Long-term
exposure to vapors can cause serious injury and
illness.
• Avoid prolonged breathing of vapors.
• Keep face away from nozzle and fuel tank or
conditioner opening.
• Keep fuel away from eyes and skin.
Biodiesel Ready
This machine can also use a biodiesel blended fuel of up
to B20 (20% biodiesel, 80% petrodiesel). The petrodiesel
portion should be low or ultra low sulfur. Observe the
following precautions:
•
The biodiesel portion of the fuel must meet specification
ASTM D6751 or EN14214.
•
The blended fuel composition should meet ASTM D975
or EN590.
•
Painted surfaces may be damaged by biodiesel blends.
•
Use B5 (biodiesel content of 5%) or lesser blends in cold
weather.
•
Monitor seals, hoses, gaskets in contact with fuel as they
may be degraded over time.
•
Fuel filter plugging may be expected for a time after
converting to biodiesel blended.
•
Contact your distributor if you wish more information
on biodiesel.
In certain conditions during fueling, static electricity can be
released causing a spark which can ignite the fuel vapors. A
fire or explosion from fuel can burn you and others and can
damage property.
•
Always place fuel containers on the ground away from
your vehicle before filling.
•
Do not fill fuel containers inside a vehicle or on a truck
or trailer bed because interior carpets or plastic truck bed
liners may insulate the container and slow the loss of any
static charge.
•
When practical, remove equipment from the truck or
trailer and refuel the equipment with its wheels on the
ground.
•
If this is not possible, then refuel such equipment on
a truck or trailer from a portable container, rather than
from a fuel dispenser nozzle.
•
If a fuel dispenser nozzle must be used, keep the nozzle in
contact with the rim of the fuel tank or container opening
at all times until fueling is complete.
DANGER
In certain conditions, fuel is extremely flammable
and highly explosive. A fire or explosion from fuel
can burn you and others and can damage property.
• Fill the fuel tank outdoors, in an open area, when
the engine is cold. Wipe up any fuel that spills.
• Never fill the fuel tank inside an enclosed trailer.
• Never smoke when handling fuel, and stay away
from an open flame or where fuel fumes may be
ignited by a spark.
• Store fuel in an approved container and keep it
out of the reach of children. Never buy more
than a 180-day supply of fuel.
• Do not operate machine without entire exhaust
system in place and in proper working condition.
Filling the Fuel Tank
1. Park the machine on a level surface.
2. Using a clean rag, clean area around fuel tank cap.
3. Remove cap from the fuel tank
1. Fuel tank cap
4. Fill the tank until the level is to the bottom of the filler
neck with diesel fuel.
5. Install fuel tank cap tightly after filling tank.
Note: If possible, fill the fuel tank after each use. This
will minimize possible buildup of condensation inside
the fuel tank.

Checking the Tire Pressure

Service Interval: Before each use or daily
The correct air pressure in the front tires is 345 kPa (50 psi )
and the rear tires is 207 kPa (30 psi)
Important: Maintain pressure in all tires to ensure a
good quality-of-cut and proper machine performance.
Do not under-inflate.
Check the air pressure in all the tires before operating
the machine.
28
(Figure 21).
Figure 21
(Figure 22).