Table of Contents
Advertisement
DO (device offline), UO (unit offline): Byte 1
(C)
This scanner ignores DO and UO.
(d) Parameter list length: Bytes 3 to 4
This scanner does not support parameter list length.
4.4.5.2
Contents of self-test
The contents of self-test shall be an equivalent of NOP, provided that CHECK CONDITION is reported if err information
is withheld in the unit.
4.4.5.3
Results of self-test
This scanner reports the results of self-test as follows:
(a) Normal
The GOOD status is returned.
• Status: B'00000' (GOOD)
• Sense key: X'O' (NO SENSE).
(b) Abnormal
If error information is being withheld, the following status is returned:
• Status: B'00001' (CHECK CONDITION)
• Sense key: Error information being withheld
4.4.6 TEST UNIT READY command
The following table shows the normal sequence of the TEST UNIT READY command when used with this scanner.
Step
1
BUSFREE
2
ARBITRATION
3
SELECTION
4
MESSAGE OUT
5
COMMAND
6
STATUS
7
MESSAGE IN
8
BUS FREE
Bus phase
Verifies bus free
Obtains bus-usage right
Select target
Selects logical unit
Specifies TEST UNIT READY (CDB)
Table 4-15
Initiator operation
4-31
← ← → →
Target
operation
→
Drives BSY
signal
→
→
Reports GOOD
status
←
Reports message
(Command
Complete)
Releases BSY
signal
Advertisement
Table of Contents
