Advertisement
Install the Device/ 设备安装
D Wall-Mount/ 壁装
Check the diameter of the cable outlet on the wall to ensure that the tails properly pass through the cable
1
outlet. Paste the drilling sticker in the camera installation position and ensure that the center of the sticker
overlaps the center of the cable outlet on the wall.
检查墙壁出线孔直径， 确保尾线可以顺利穿过出线孔。 将安装定位贴纸贴在摄像机安装位置， 贴纸中心请对准墙壁出线孔。
Connect the cables to the tails of the camera, perform insulation operations on the cables (see Connect
3
Cables), and put the cables through the cable entry on the wall. Fasten the ST3.9 tapping screws. The cable
outlet at the camera base must face downward during installation and be sealed with waterproof glue to
prevent water from getting into the camera.
将线缆与摄像机的尾线连接，对线缆进行绝缘处理（参见"连接线缆"），然后塞入墙壁出线孔。拧紧 ST3.9
摄像机底座的出线口在安装时须朝下方，并用防水胶密封，防止水流入。
NOTE/ 说明
In the preceding method, the tails pass through the wall. If you do not want the tails to pass through the
wall, pass the tails through the cable outlets on the base.
上述安装方式为尾线穿墙安装，若尾线不穿墙安装，请直接将尾线从底座侧面出线口穿出即可。
Obtain a drill bit with a 5 mm diameter and drill four 35 mm holes in the specified positions marked by the
2
stickers. Use a claw hammer to install the expansion tubes into the holes.
依照贴纸上的标注，选择直径为 5mm 的钻头，钻取深约 35mm
Unfasten the three hex socket screws, adjust the camera to the required surveillance angle, and fasten the hex
4
socket screws.
拧松支架的 3 个内六角螺钉，调整摄像机监控角度至所需位置，再拧紧内六角螺钉。
自攻螺钉。
NOTE/ 说明
After adjusting the camera's surveillance angle, if the image still blurs due to out-of-synchronization of
the lens after automatic or manual focus, log in to the IPC web page, and click the
lens. For details, see the Configuration Guide.
调整完毕后，在自动对焦或者手动聚焦后图像仍然模糊（由镜头失步引起的虚焦），请登录Web页面，单击
位镜头，具体请参见《配置指南》。
的导孔。使用羊角锤将膨胀管打入钻好的孔内。
icon to reset the
复
Advertisement
