Table of Contents
Advertisement
1.0
ABB con rms the tool described in this instruction manual complies with the basic safety and health requirements of
EC Machinery Directive 2006/42/EC and EMC Directive 2004/108/EC relating to electromagnetic compatibility.
1.1
WARNINGS & SAFETY RULES
WARNINGS
1. BE FAMILIAR WITH YOUR TOOL.
Read the instruction manual. Become aware of its proper
usage as well as the potential hazards.
2. NEVER ATTEMPT TO MAKE A COMPRESSION ON A
"HOT" LINE. HIGH VOLTAGE!
• Never assume the power is OFF! Determine beforehand
if any electrical hazards could exist when making a
connection to a line or wire.
• Tools are NOT insulated for use on or near energized
conductors. Use of these tools near energized
conductors may lead to electrical shock, causing severe
injury or death. DO NOT use these tools near energized
conductors without adequately insulating operator and
surroundings.
3. KEEP FINGERS AND OTHER BODY PARTS AWAY
FROM COMPRESSION DIES & MOVING PARTS.
Pinch point hazard. Compression Dies at high force can
cause severe personal injury. Keep all body parts away
from moving parts of the tool during operation.
4. DO NOT SHORT CIRCUIT THE BATTERY.
5. WEAR ALL REQUIRED PERSONAL PROTECTIVE
EQUIPMENT.
6. DO NOT DISPOSE OF TOOL OR BATTERY AS
RESIDUAL WASTE. RECYCLE EXHAUSTED
BATTERIES. TOOL CONTAINS HYDRAULIC OIL,
CIRCUIT BOARDS, AND OTHER COMPONENTS
WHICH MUST BE DISPOSED OF SEPARATELY
ACCORDING TO LOCAL ENVIRONMENTAL
STANDARDS.
1
2
5
5
SAFETY RULES
1. KEEP WORK AREA CLEAN AND WELL LIGHTED.
Poor lighting and cluttered areas invite accidents.
2. MAINTAIN TOOL WITH CARE. Keep tool in good
condition at all times. Keep it clean for best and safest
performance.
3. DON'T OVER-REACH. Keep proper footing and balance
at all times.
4. NEVER OPERATED TOOL WITHOUT CRIMPING DIES
INSTALLED. Ensure connector material is inserted
between dies before compression.
IMPORTANT: Read and understand all of the
instructions and safety information in this manual
before operating or servicing this tool.
GENERAL INFORMATION
3
4
5
6
1.2
FEATURES
• Fully automatic, self-contained power tool.
• Removable battery cartridge - simply change the
cartridge for continuous use.
• One handed operation.
• Fully enclosed weather resistant housing.
• LED work lights.
1.3
SPECIFICATIONS
HYDRAULIC COMPRESSION TOOL:
B-CK240
Drive Unit:
14.4V DC Motor
Dimensions:
425 mm L x 89 mm W x 144 mm H
Weight:
2.6 kg without battery
Capacities:
6-240 mm
Jaw Opening:
45 mm
Output:
52 kN
BATTERY:
BAT-LI34
Battery Type:
Sealed Lithium Ion
Voltage:
14.4V DC
Dimensions:
110 mm L x 70 mm W x 130 mm H
Capacities:
3.3 Ah
Weight:
0.56 kg
Charging time: 60 minutes
CHARGER:
BATC-230
Input Voltage: 230 V, 50 Hz
Dimensions:
150 mm L x 90 mm W x 85 mm H
Weight:
0.5 Kg
IN ORDER TO OBTAIN WARRANTY SERVICE YOU
MUST REGISTER YOUR PRODUCT BY LOGGING
IN ON www.tnb.com/toolregistration. FAILURE TO
REGISTER YOUR PRODUCT VOIDS ALL
WARRANTIES.
2
TA04902 C Page 2 of 8
Advertisement
Table of Contents
