Table of Contents
Advertisement
AP2030DN
Hardware Installation and Maintenance Guide
2.5 Installing the Device
l The device should be isolated from strong electricity to ensure personal security and
l Remove the protective film on the surface before installation to prevent electrostatic
In most cases, the device is installed into an 86-type box in China. To install the device in another way,
purchase mounting brackets.
2.5.1 Installing the Device into an 86-Type Box
1.
2.
3.
Issue 05 (2016-07-22)
NOTICE
prevent device damages.
discharge.
NOTE
Use a screwdriver to remove the 86-type panel from the wall (skip this step if no 86-type
panel is installed on the wall).
Connect the network cable to the GE/PoE interface and the phone cable to the phone
interface.
Install the device that has cables properly connected to the 86-type box, as shown in the
following figure.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 AP Installation
11
Advertisement
Table of Contents
