Table of Contents
Advertisement
Technical data | SYDFED-2X, SYDFED-3X, SYHDFED-1X
3. In some cases, the pump will not swivel out to the positive stop. For this
reason, switch the motor on briefly, then switch off, wait until the pump has
swiveled out and check the actual swivel angle value. If the actual swivel
angle value of 100 % ±1 % cannot be reached, switch on drive motor and start
calibration of swivel angle sensor factor.
16 Technical data
The technical data of your SY(H)DFED system are contained in the following data
sheets:
SYDFED series 2X
SYDFED series 3X
SYHDFED series 1X
You can find the data sheets on the Internet at
www.boschrexroth.com/ics
The pre-set technical data of your SY(H)DFED control system are listed in the
order confirmation.
Further descriptions and information as well as the engineering tool IndraWorks
can be found on the Rexroth website in the product portal "SY(H)DFED":
https://www.boschrexroth.com/sydfe
https://www.boschrexroth.de/indraworks
RE 30030
RE 30630
RE 30035
RE 30017-B, Edition 11.2021, Bosch Rexroth AG
87/96
Advertisement
Table of Contents
