Product- And Technology-Related Safety Instructions - Bosch rexroth SYDFED 2X Series Manual

12/96 SYDFED-2X, SYDFED-3X, SYHDFED-1X | Safety instructions
Bosch Rexroth AG, Edition 11.2021, RE 30017-B
2.6 PRODUCT- AND TECHNOLOGY-RELATED SAFETY
INSTRUCTIONS
Control system falling down!
SY(H)DFED control systems are heavy. When improperly handled, they can fall
down and cause severe injuries and crushing, because the parts can be, for
example, sharp-edged, heavy, oily, loose or bulky.
▶ Transport the SY(H)DFED control system using suitable lifting gear at the
points provided for this purpose.
▶ Ensure a stable position while transporting the control system to the place of
installation.
▶ Wear personal protective equipment when transporting the control system.
▶ Comply with the national laws and regulations regarding occupational health
and safety for transporting/handling.
Systems not shut down!
Working on running systems poses a danger to life and limb. The work steps
described in these operating instructions may only be performed on shut down
systems. Before beginning work:
▶ Make sure that the drive motor cannot be switched on.
▶ Make sure that all power-transmitting components and connections
(electrical, pneumatic, hydraulic) are switched off according to the
manufacturer's instructions and are secured against being switched on again.
If possible, remove the main fuse of the system.
▶ Ensure that the system is completely hydraulically unloaded and
depressurized. Please follow the system manufacturer's instructions.
▶ Only qualified personnel (see chapter 2.4"Qualification of personnel" on page
11) are authorized to install the SY(H)DFED control system.
Lines under pressure!
Risk of injury.
▶ Never disconnect, open or cut pressurized lines!
▶ Before carrying out any installation or other work, depressurize the control
system.
High electrical voltage!
Danger to life and risk of injury due to electric shock.
▶ Before starting installation work, plugging and unplugging connectors and
carrying out any work, switch the control system off. Secure the electrical
equipment against restarting.
▶ Before switching the control system on, check the protective conductor on all
electrical devices for proper connection according to the wiring diagram.
WARNING