Refilling The Water Tank - Sharp EH-HS41 Manual

REFILLING THE WATER TANK

The unit can be used in the Clean Air Mode without
putting water in the Water Tank. When using in the Hu-
midify Mode, the Water Tank should be filled with water.
1 Remove the Water Tank by unlatching the
top.
2 Remove the Tank Cap and carefully fill the
Water Tank with tap water.
Change the water in the Water Tank every day with
fresh tap water.
3 After filling, securely tighten the Tank Cap.
• Check to see that there is no water leaking.
• Be sure to wipe off any excess water on the outside of
the Water Tank.
• When carrying the Water Tank, hold it with both hands
so that the Water Tank opening is facing up.
Replace the Water Tank in the unit.
4
The top latch will "click" in place when the Water Tank is
properly installed.
CAUTION
• Do not expose the unit to water. Short circuit and/or electrical shock may occur as a result.
• Do not use hot water (40 ºC), chemical agents, aromatic substances, dirty water, or other
damaging substances, deformation and/or malfunction may occur.
• Use only fresh tap water. Use of other water sources may promote the growth of mold, fun-
gus and/or bacteria.
KC-930TA.indd 27
Tank Cap
E-7
09.9.30 2:22:58 PM