Reset And Tamper Headers; Reset Header; Tamper Header - DMP Electronics XR550 International Series Installation Manual

Hide thumbs Also See for XR550 International Series:

Testing manual (8 pages)

User manual (88 pages)

Troubleshooting manual (40 pages)

Table Of Contents

Table of Contents

18.1 RESET Header

The RESET header is located to the left of the Expansion Header

(EXP) on the right side of the circuit board and is used to reset the

XR150INT/XR550INT Series microprocessor. To reset the panel when

first installing the system, install the reset jumper before applying

power to the panel. After connecting the AC and battery, remove the

reset jumper.

To reset the panel while the system is operational, for example, prior

to reprogramming, install the reset jumper without powering down the

system. Remove the reset jumper after one or two seconds.

After resetting the panel, begin programming within 30 minutes If you

wait longer than 30 minutes, you must reset the panel again.

18.2 TAMPER Header

The TAMPER header is for use with the optional DMP 306 Tamper

Harness. The harness connects to one or more tamper switches

mounted inside the panel enclosure to supervise against unauthorized

enclosure opening or removal. Refer to the wiring diagram on the

enclosure door for correct tamper switch wiring.

How the Tamper Works

If the enclosure is opened or removed while one or more of the system

areas are armed, a panel tamper alarm is indicated. If all areas are

disarmed, a panel tamper trouble is indicated.

XR150INT/XR550INT Series Installation Guide