DMP Electronics 1100XH Series Installation Manual

1100XH SERIES HIGH POWER
WIRELESS RECEIVER
Installation Guide
WALL
TAMPER
ENABLE
DISABLE
Figure 1: 1100XH
High Power Wireless
Receiver
DESCRIPTION
The 1100XH Series High Power
Wireless Receiver provides up to
100 wireless zones for XR150 Series
panels and up to 500 wireless
zones for XR550 Series
panels. The 1100XHE features
128-bit AES encryption.
The 1100XH provides two-way,
supervised communication using
900 MHz frequency hopping-
spread-spectrum technology.
The 1100XH contains additional
transmit and receive amplifiers to
enable 1100 Series operation at
greater distances or harsh building
environments. The additional gain
introduced by this amplification
may inhibit proper communication
with 1100 Series transmitters
located within 4 ft of the receiver.
This distance may be 8 ft when
using the 1122 PIR or 9000 Series
Wireless Keypads.
The 1100XH is equipped with a case
and wall tamper.
Compatibility
• XR150/XR550 Series Panels
• Encryption requires panel
Version 183 or higher
• 1100T Translator requires
receiver firmware Version
207/301 or higher
What is Included?
• 1100XH Series High Power
Wireless Receiver
• Model 300 Harness
• Hardware Pack
1
RF RX
RF TX
PANEL RX
PANEL TX
STATUS
PWR
2
3
PROGRAM THE PANEL
Refer to the panel programming guide as needed.
1. Reset the panel.
2. At a keypad, enter 6653 (PROG) to access the
PROGRAMMER menu.
3. In SYSTEM OPTIONS, program a HOUSE CODE between
1 and 50. See House Code Explained for more information.
(1100XHE only) At the 1100 ENCRYPTION prompt, select
4.
ALL to only add encrypted wireless devices to the system.
Select BOTH to allow both encrypted and non-encrypted
wireless devices to be programmed.
5. (1100XHE only) The default passphrase appears at
ENTER PASSPHRASE. Press CMD to keep the default. Press
any select key or area to change the passphrase and enter
an 8-character hexadecimal string (0-9, A-F).
Press CMD until STOP displays. Press a top row select key
6.
or area to save programming.
SELECT A LOCATION
The receiver should be centrally located between the DMP panel
and the 1100 Series transmitters used in the installation based
on the wiring specifications below. Use an 1106 Series Universal
Wireless Transmitter to perform an LED survey.
1. With the cover removed, hold the transmitter in the desired
location.
2. Press the tamper switch to send data to the panel and
determine if communication is confirmed or faulty.
Confirmed: If communication is confirmed, for each
press or release of the tamper switch, the LED blinks
immediately on and immediately off.
Faulty: If communication is faulty, the LED remains on
for about 8 seconds or flashes multiple times in quick
succession. Relocate the receiver until the LED confirms
clear communication.
MOUNT THE 1100XH
1. Remove the cover from the plastic housing.
2. Use the included #6 screws to secure the 1100XH to the
wall. See Figure 2 for mounting hole locations.
3. Use one of the provided screws to anchor the housing
in the wall tamper screw hole. See Figure 2 for tamper
location.
Figure 2: Inside of the 1100XH Housing
Tamper Puck
Mounting Hole