Table of Contents
Advertisement
ANNUAL MAINTENANCE
Perform the following tests annually to confirm that the diagnostics are functioning properly and to verify the integrity of
the case.
Check the Integrity of the Pads and Circuitry
1.
Open the AED lid.
2.
Remove the pads.
3.
Close the lid.
4.
Confirm that the STATUS INDICATOR turns RED.
5.
Open the lid and confirm that the PAD indicator is lit.
6.
Reconnect the pads and close the lid.
7.
Make sure the expiration date is visible through the clear window of the lid.
8.
Check to make sure that the STATUS INDICATOR is GREEN.
9.
Open the lid and confirm that no diagnostic indicators are lit.
10. Check the expiration date of the pads; if expired, replace them.
11. Check the pad's packaging integrity.
12. Close the lid.
Check the Integrity of the Service Indicator (LED) and Circuitry
1.
Immediately after opening the AED lid, press and hold the SHOCK button and confirm that the
SERVICE LED is lit.
2.
Release the SHOCK button.
3.
Close the lid.
4.
Verify that the STATUS INDICATOR remains RED.
5.
Open the lid and confirm that no diagnostic indicators are lit.
6.
Close the lid.
7.
Verify the STATUS INDICATOR turns GREEN.
Check the Integrity of the Case
Examine the molded case of the AED for any visible signs of stress. If the case shows signs of stress, contact Customer
Service or your local distributor.
Cleaning the AED Case
Gently clean the surface of the AED case with a damp sponge or with a cloth and mild soap.
CAUTION: Case Cleaning Solutions
When disinfecting the case, use a non-oxidizing disinfectant, such as ammonium salts or a
glutaraldehyde based cleaning solution, to avoid damage to the metal connectors.
No periodic safety analysis tests referred to by the IEC 60601-1 international standard are
required.
2023491-201 Rev B
SECTION 3 – MAINTENANCE AND TROUBLESHOOTING
© 2007 General Electric Company
Page 23 of 33
Advertisement
Chapters
Table of Contents
Troubleshooting
