Table of Contents
Advertisement
1-6. Installation of Track Ball
The track ball is not installed in BKDM-3010 at the
factory.
Install the track ball according to the following procedures.
1. Turn the ball cover counterclockwise and loosen it,
then remove.
2. Catch the Z-ring on a nail, raise it, then remove.
3. Put a track ball in the position shown in the figure.
Loosen
4. Push in the Z-ring while pressing it against the Z
sensor plate.
5. Turn the ball cover clockwise and tighten it.
Z-ring
Track ball
Tighten
Ball cover
Z-ring
Track ball
Z sensor plate
Track ball
Z-ring
Z sensor plate
Z sensor plate
1-7. Rack Mounting
DME-3000/7000 can be mounted in a 19-inch standard
rack.
n
• If DME-3000/7000 and a peripheral equipment are
mounted in a 19-inch standard rack, it is recommended
to install a ventilation fan to prevent a temperature rise in
the rack.
Make sure that all the units in the rack should be
operated within the temperature range of 5 ˚C to 40 ˚C.
• Be sure to use the recommended rail when rack mount-
ing. The unit cannot be installed completely to a rack by
rack angles alone.
• Be sure to fix the rack to the floor with bolts. When the
unit is pulled out from the rack, this will prevent its fall.
• An installation manual is supplied with the rack mount
rail RMM-30. However follow the instructions in this
maintenance manual. Because the rack mounting
procedures of DME-3000/7000 differ somewhat from
the procedures explained in RMM-30 installation
manual.
[Required parts]
• Rack mount rail (RMM-30)
Rail with bracket:
X
Screw (B5
8):
• Screw for rack mounting (RK5
• Washer for rack mounting:
(Sony part number: 2-297-913-01)
X
• Screw (BVTT4
8)
(*)
:
(*) : Supplied with DME-3000/7000.
c
Be sure to use the optional rack mount rail RMM-30.
If a rack mount rail not in designation is used, the unit may
be dropped by a low strength. This may cause a injury.
1-6. Installation of Track Ball
1-7. Rack Mounting
2 pcs
8 pcs
X
16): 4 pcs
4 pcs
6 pcs
1-11 (E)
Advertisement
Table of Contents
