Table of Contents
Advertisement
CAUTION for LAN port
For safety, do not connect the connector for peripheral
device wiring that might have excessive voltage to the
following port:
• LAN2 port
Notes
• When you connect the LAN cable of the unit to
peripheral device, a shielded-type cable is strongly
recommended to prevent malfunction due to radiation
noise and electrostatic noise.
• If a redundancy configuration is not used on the
network, use the LAN1 port.
DC IN connector
Connect to the supplied AC adapter.
Preparations
Notes on Installation
For installing the unit in a 19-inch rack
When installing in a 19-inch rack, use binding-head screws
(+B5×10, 7-682-575-04).
For use in an OB van
When the unit is to be used in an OB van, be sure to bind
the cables to a rack strut to avoid having the weight of
cables add to vibration shock to the connector on the side
panel during transport.
Setting Up the Unit
First, configure the network preferences using the buttons
on the unit. For details about network preferences and
connection mode settings, refer to the Installation Manual.
You can enter the IP address specified for the unit in a web
browser to display the web menu. Use the web menu to
configure detailed settings.
Connections with System Controllers
and LEO
A remote control panel can be connected in a single
system connection or in a redundancy system connection.
Several modes are supported for redundancy system
connections.
Single system connection
A single system connection is the simplest connection
type.
Use LAN1.
MKS-R4020
Dual LAN redundancy system connection
A dual system redundancy structure uses both LAN1 and
LAN2 of the remote control panel.
Operation will continue in the event of a single system
switch failure.
MKS-R4020
Note
When using a dual LAN1 and LAN2 system connection, do
not use IP addresses for the same segment.
6
IP Live System Manager
LAN1
or
LEO
IP Live System Manager (A)
LAN1
LAN2
IP Live System Manager (B)
Advertisement
Table of Contents
