Hitachi CE50-10 Instruction Manual page 128

5. Configuring Software Environment
Item
Finished: 20210525101010_sda8_0
(g)
1.gz
Finished: 20210525101010_etc_01
.tgz
Successfully completed
(h)
4. To restore data from the maintenance PC, enter 2, and then press the Enter key.
This selects restoration from the maintenance PC, and then the following screen appears.
Making partitions finished.
OK
Restoring from maintenance PC.
Please send 20210525101010_sda8_01.gzto /mnt/ecbackup_data/. Finished? (y)...(j)
Restoring: 20210525101010_sda8_01.gz
31MiB 0:00:01 [16.1MiB/s] [====>
Will you verify restored area(y / N)?y
Verifying: 20210525101010_sda8_01.gz
The file and the partition doesn't match. Retry?(y / N)
Restoring: 20210525101010_sda8_01.gz
31MiB 0:00:01 [16.1MiB/s] [====>
Finished: 20210525101010_sda8_01.gz
(snip)
Will you verify restored directory(y / N)?
Verifying: 20210525101010_sda8_01.gz
The file and the directory doesn't match. Retry?(y / N)
Finished: 20210525101010_etc_01.tgz
Successfully completed
$
Table 5‒29: Description of the screen after restoration from the maintenance PC started
Item
(a) to See Table 5‒28: Description of the screen after
(h) restoration from external media started.
Restoring from maintenance PC.
(i)
Please send 20210525101010_sda8_01
(j)
.gzto /mnt/ecbackup_data/.
ed? (y)
5. Enter q, and then press the Enter key:
The ecrestore command terminates.
If you enter any other data, the prompt character (>) appears and the system waits for you to enter information
again.
For details about running the command, see 5.15.4 Restoring backup data.
<Diagnosis>
For the exit code, 0 is returned if the status is normal and 1 is returned if an error is detected. Table 5‒30: List of
ecrestore command error messages below shows error messages that are output when an error is detected.
Table 5‒30: List of ecrestore command error messages
No.
1 Restore failed.
112
Display
Display
Error message
Restoration failed due to an error.
This message indicates that restoration of the relevant
backup files finished normally.
Messages (c) through (g) are displayed for all the files in
the specified directory.
This message indicates that restoration of all backup files
finished normally.
(start=0 size=123456)
] 25% ETA 0:00:02
(start=0 size=123456)
(start=0 size=123456)
] 25% ETA 0:00:02
(start=0 size=123456)
See Table 5‒28: Description of the screen after
restoration from external media started.
This message indicates that restoration from the
maintenance PC started.
This message asks you to transfer the backup file.
Finish
When this message appears, place the specified backup
file in /mnt/ecbackup_data. After placing the
file, enter y, and then press the Enter key to go to the
next display.
Description
Description
...(a)
...(i)
...(c)
...(d)
...(e)
...(e)
...(f)
...(c)
...(d)
...(g)
...(e)
...(e)
...(f)
...(g)
...(h)
Description
Action
Eliminate the cause of the error by
referring to other error messages,
and then rerun the command.