Table of Contents
Advertisement
To put a call on hold and switch from Call 1 to Call 2:
1
Whilst a call is in progress, a beep sounds to indicate a second incoming call.
Replace
Select
to take Call 2 and end Call 1, select
[Send] key to put Call 1 on hold and take Call 2.
Press the [End/Off] key to end Call 1 and press the [Call/Send] key to take Call 2.
2
Options
Select
then select
To set up a conference-call
You can set up a conference-call with up to 5 participants. This option is network/subscription
dependent.
1
Whilst two calls are in progress and a new call is received, select
then press the [Call/Send] key to set up the conference-call. Repeat the action each time
a new call is received.
During the conference-call, the following Options menu is available:
In compliance with European regulations, you are obliged to inform your correspondents before
recording a phone conversation.
OPTIONS
DESCRIPTION
Speaker On/Off To activate/deactivate the hands free mode.
Auto-DTMF
To type a new phone number and add this new correspondent to the
conference-call. If the Auto-DTMF option is deactivated, you cannot type in
a new phone number.
Private with
To have a private conversation with one of the participants. During a private
conversation, the conference-call is put on hold.
Hold
To put the conference-call on hold.
Retrieve
To retrieve the conference-call if it is put on hold.
Mute/Unmute
To mute/unmute the microphone.
End one
To end one call.
End all
To end the conference-call.
Record
To record the conference-call up to 11min.
You can set up and receive a new call during the conference-call. In these cases the conference-call is put on
hold.
To end a conference-call:
1
Press the [On/Off] key or select
Sending my ID
You can disable the sending of your own number on a call by call basis by adding #31# before
the number you are dialling. You can also ask your service operator to hide your mobile phone
number by default. Once hidden by your operator, you can show your number, on a call by call
basis, by entering *31# before the number you are calling.
To check the Sending my ID status:
1
Press the [Menu/T9] key. Select Settings.
2
GSM
Services.
Select
3
Sending my
ID.
Select
4
Select Status. The request is launched and an information message displays the Sending
my ID status.
To hide or show your ID:
1
Press the [Menu/T9] key. Select Settings.
2
GSM
Services.
Select
3
Sending my
ID.
Select
4
My
settings.
Select
5
Hide my ID
Select
to prevent the mobile from sending your ID when making a call, select
Show my ID
to allow the mobile to send your ID or select
factory/operator setting.
Please contact your service provider for more information.
Reject
to refuse Call 2 or press the Call/
Swap
to get back to Call 1 and put Call 2 on hold.
Options
End all
then
to end the conference-call.
Preset
Settings
91-
Options
Join
then
or press
to get back to the default
Advertisement
Table of Contents
