Toro 30826 Operator's Manual page 27

Standard Angle Sail
Grass Cutting: .75
Recommended in
to 1.75 inch Height
most applications
of Cut
Grass Cutting: 2.00
Recommended for
to 2.50 inch Height
thick or lush turf
of Cut
Grass Cutting: 2.75
May work well in
to 4.00 inch Height
of Cut
Recommended for
Leaf Mulching use with the
mulching baffle
Even discharge at
lower height of cut
Cleaner look around
bunkers and fairways
Lower power
requirements
Does not lift the grass
well in high height of
cut applications
Wet or sticky grass
has a tendency to
build up in the cham-
ber, leading to poor
quality of cut and
higher power require-
ment
Optional Equipment Configuration
High Lift Parallel
Sail Blade
DO NOT USE
Blade
WITH MULCHING
BAFFLE
May work well in
light or sparse turf
Recommended for
light or sparse turf
Recommended in
lush turf most applications
NOT ALLOWED
More lift and higher
discharge velocity
Sparse or limp turf is
picked up at high
height of cut
Wet or sticky
clippings are
discharged
efficiently
Requires more power
to run in some ap-
plications
Tends to windrow at
lower height of cut in
lush grass
DO NOT USE
WITH MULCHING
BAFFLE
27
Mulching Baffle Roller Scraper
Has been shown to
improve dispersion
and after cut perfor-
mance on northern
grasses that are cut at grasses that are cut at
Can be used any time
least three times per
that rollers build up
week and less than
with grass or large
1/3 of the grass blade
flat grass clumps of
is removed. is removed.
grass are seen. The grass are seen The
DO NOT USE
scrapers may actually
WITH THE HIGH
increase clumping in
LIFT PARALLEL
certain applications.
SAIL BLADE
Use with standard
angle sail blade only
May improve disper- Reduces roller
sion and appearance buildup in certain
in certain grass applications
cutting applications
Very good for leaf
mulching
Grass will build up in
the chamber if
attempting to remove
too much grass with
baffle in place