CHAPTER 4: USING THE METER
Note
4.3.6
Configuring the Connection Setting
EPM 6000 MULTI-FUNCTION POWER METERING SYSTEM – USER GUIDE
This will display the and the
Press ENTER again to change to display the
screen.
Press ENTER again to select the to
The
value can be "1", "10", or "100". Refer to Programming the Configuration Mode
Pt-S
Screens on page 4–10 for instructions on changing values.
Example settings for the
Pt-n
•
14400/120 V (reads 14400 V): set
to "10"
•
138000/69 V (reads 138000 V): set
to "100"
•
345000/115 V (reads 347000 V): set
to "100"
Pt-S
Press ENTER to scroll through the other
Press DOWN or RIGHT to display the password screen (see Reset
Mode and Password Entry on page 4–6 for details).
Press MENU to return to the main configuration menu.
and
are dictated by primary voltage.
Pt-n
Pt-S
Use the following procedure to program the connection (
(PT numerator) screen.
Pt-n
,
, and
values are shown below:
Pt-d
Pt-S
Pt-n
Pt-n
Pt-n
Pt-d
(PT denominator)
Pt-d
(PT scaling) value.
Pt-S
to "1440", Pt-d to "120", and
to "1380", Pt-d to "69", and
to "3450", Pt-d to "115", and
parameters.
CFG
is secondary voltage.
) setting.
Cnct
Pt-S
Pt-S
4–13