Sealey AK39602.V2 Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instruction protection
manual
1. SAFETY
WARNING! Ensure Health & Safety, local authority and general workshop practice regulations are adhered to when using this equipment.
‰
WARNING! Always wear approved eye or face protection when operating the riveter.
‰
DO NOT hold the workpiece by hand. Secure workpiece with a clamp, vice or other adequate holding device.
8
DO NOT use the riveter for any purpose other than that for which it is designed.
8
DO NOT operate the riveter if any parts are damaged or missing, as this may cause failure and/or personal injury.
8
Familiarise yourself with the application and limitations of the riveter, as well as the potential hazards.
9
Maintain the riveter in good condition (use an authorised service agent).
9
Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
9
Keep the work area clean, uncluttered and ensure that there is adequate lighting.
9
Keep the riveter clean for best and safest performance.
9
Keep children and unauthorised persons away from the work area.
9
Check moving parts alignment on a regular basis.
9
When not in use return to the case and store in a safe, dry, childproof area.
9
2. INTRODUCTION
i
Drop forged frame with patented folding mechanism for compact storage. Comfortable cushion grips. Suitable for installing threaded nut
rivets for securing threads in thin sheet material. Heavy-duty head accepts threaded rivets up to M10. Suitable for aluminium and steel
nut rivets and pop rivets.
3. SPECIFICATION
i
Model No: ............................................................... AK39602
Rivet Nuts ...................................................................... 5 Off
Blind Rivet Sizes: ............................... 3.2, 4, 4.8, 6.0, 6.4mm
Folded Length: ........................................................... 285mm
Unfolded Length: ........................................................ 510mm
Rivet Materials: ..................Aluminium, Steel, Stainless Steel
4. CONTENTS
Check the contents of the kit against the item list and fig.1.
If any item is found to be damaged or missing contact your
Sealey stockist immediately.
1. Riveter
2. Pop Rivet Mandrels, 5 (1 in riveter)
3. Nut Rivet Mandrels & Bars, 5, M4 x 0.7, M5 x 0.8, M6 x 1.0, M8 x 1.25, M10 x 1.5
4. Nosepiece for Nut Rivet Mandrel
5. Spanners, 5.5/8.5mm, 12/17mm, 15/19mm
5. APPLICATIONS
The AK39602 kit is suitable for fitting threaded nut rivets of the following materials and sizes together with pop rivets up to
6.4mm (1/4") diameter.
Thread
Aluminium
Steel
© Jack Sealey Limited
RIVET AND THREADED NUT RIVET KIT
MODEL NO:
M4 x 0.7 M5 x 0.8
Original Language Version
AK39602.V2
fig.1
M6 x 1.0 M8 x 1.25 M10 x 1.5
AK39602.V2 Issue 2 (4,9)18/03/19