Canon PRISMAsync v3.2 Technical & Service Manual page 90

Firmware upgrade of Engine and Accessories (safe download mode)
step Action
9
Reboot to start installation
Press 'OK' to reboot the printer and to
continue with the upgrade.
After pressing 'OK' the printer will re-
boot and start installing firmware pack-
ages.
10 Switch off and on the printer
When the process is completed a screen
is displayed prompting you to switch the
printer off and on again.
Take the following steps:
1. Restart the printer
2. Select [OK]
11 Leave firmware upgrade mode
Press [Close] to leave the firmware Up-
grade mode.
12 Remove USB key with Printer firmware
Check the versions
90 Chapter 8 - Firmware upgrades via PRISMAsync
NOTE
If your system does NOT have
a READER attached you might
get an error message in the
feedback screen. You can ig-
nore the message. The instal-
lation will continue without
any problems.
Switch off the printer with the
power switch
Switch off all accessories (finish-
ing, paper-decks etc.)
Switch on all accessories
Switch on the printer with the
power switch
additional Info
The duration of the printer upgrade procedure
depends on the configuration that is installed.
Example: Main Engine, POD Deck, Finisher
AJ2 and 3 knife trimmer will take approx. 45
minutes.
If a HCS-F1/G1 is connected the additional
time will be approx. 30 minutes.
PRISMAsync V3.2