Install/Replace The Ethernet Board - Canon PRISMAsync v3.2 Technical & Service Manual

Install/Replace the Ethernet board

The extra Ethernet board (Intel PRO/1000 GT Desktop Adapter) is needed when IPDS functionality
is enabled (Extra license). The board is needed for the Codishell tool to analyse IPDS-problems. It
can also be used to connect the laptop to the PRISMAsync.
NOTE
When servicing components of the PRISMAsync always wear a grounded strap around your
wrist, to avoid electrostatic discharge that will harm your equipment.
Step Action
Remove side cover and middle bracket.
1
• Follow the instructions as described in
Unpack the new board.
2
3 Remove the fifth metal bracket (starting from the CPU).
• Use a Philips screwdriver to remove the bracket..
Place the board in the PCI connector.
4
• Firmly press the board in the PCI connector.
5 Fasten the Ethernet board.
• Fasten the board with a single screw on the PCI bracket side with a Philips screw-
Re-install middle bracket and side cover.
6
• Make sure the fixing on the middle bracket is in position. It should fit exactly on the
7 Re-install system software
• If the Ethernet board is installed for the first time (no replacement) there will be no
PRISMAsync V3.2
NOTE
Make sure to use the indicated slot.
driver.
Ethernet board.
driver installed for it. Therefore you have to re-install the PRISMAsync software.
Install/Replace the Ethernet board
Access internal components on page
Chapter 7 - Service procedures
67.
75