Changing The Ip Controller's Ip Address - Canon CR-G100 Instruction Manual

4 Configuration
1. Launch the web browser on the control PC and access the following URL.
http://<IP address>
 At initial settings, the IP controller's IP address is set to [192.168.0.1].
2. Only the first time
 The password change screen will appear only when you access the system for the first time (or the first time
after resetting the system).
3. Only the first time
 The IP address setup screen will appear only when you access the system for the first time (or the first time after
resetting the system).
4. Launch the web browser and access the URL as in step 1.
 This time, use the IP address that you set in step 3.
 When the login screen is displayed, you can bookmark the web page in the web browser.
5. Enter the user name and password and click [Login].
 The user name is [admin]. Log in with the password that you set in step 2.
 Changing the IP Controller's IP Address
1. Enter the desired IP address (other than 192.168.0.1), subnet
mask and default gateway (if necessary), and then click [Set].
 When the IP address is changed, the IP controller will restart
automatically. It will take about 1 minute until you can access it
again.
 After the IP controller restarts, you can log in to the URL that
includes the new IP address.
http://<New IP address>
If you forget the IP address or password, you will need to reset all the IP controller's settings.

Enter the same password twice and click [Set].
Set the IP controller's IP address (A 15).
15
Starting Up the Web Setup Tool