Preparations - Canon RC-IP100 User Manual

N [CAMERA CONTROL]
For controlling the currently selected camera.
O [FUNC]
For changing the settings of the currently selected camera.
P [TRACE]
For recording the camera operations of the currently selected
camera to replicate the operations at a later time.
Q [PT ACTIVE]
Tap the button to switch [PT ACTIVE] on and off. Switching
to off disables the pan/tilt operation by the control lever.
R [DELETE]
Tap the button to enter [DELETE] mode.
S [STORE]
Tap the button to enter [STORE] mode.
T [VIEW]
Tap the button to enter [VIEW] mode.
U [CAMERA/PRESET]
For selecting a camera number or preset number.

Preparations

1 Set the power switch to "On".
0 The power is turned on and the POWER lamp lights up.
0 The start screen is displayed on the operation panel.
The ALARM lamp lights up at the same time. During which,
this unit cannot be operated.
0 The start screen disappears after about 10 seconds and
the home screen is displayed.
2 Configure the settings of this unit.
0 Set the IP address of this unit as follows.
A Select [SETTINGS] on the home screen of the
operation panel.
0 If the home screen does not appear, select
[HOME] to display the home screen.
B Select [Network].
C Select [CONTROLLER].
0 The IP address setting screen appears.
D Enter the IP address and tap [ENTER].
3 Configure the camera settings.
0 Configure the camera to be operated as follows.
A Select [SETTINGS] on the home screen of the
operation panel.
0 If the home screen does not appear, select
[HOME] to display the home screen.
B Select [Network].
C Select [CAMERA REGISTRATION].
D Perform registration according to the camera to be
connected.
0 IP camera: Select [AUTO] or [Manual]
0 Serial camera: Select [Serial Activate 1] or [Serial
Activate 100]
Memo :
0 For details on the settings, please refer to "Camera
Network Settings" (A P 16).
0 To add or change the camera to be operated, perform the
above procedures again.
Name of Parts
7